Search results
Results From The WOW.Com Content Network
The Aluminator 5.2 XS is another variant of the Coyote engine utilizing the 5.2 L cylinder block from the GT350. The Aluminator is differentiated from the Voodoo engine by a Cobra Jet intake manifold and throttle body and a cross-plane crankshaft. [47] The engine has a claimed output of 580 hp (433 kW) and 445 lb⋅ft (603 N⋅m).
The 428 Cobra Jet was a performance version of the 428 FE. Launched in April 1968, it was built on a regular production line using a variety of cylinder heads [30] combined with a 735 CFM Holley four-barrel carburetor. The Cobra Jet used heavier connecting rods with a 13/32 rod bolt and a nodular iron crankshaft casting #1UB.
Ford developed two high-performance street versions of the 429 between 1969 and 1971, the Cobra Jet and Super Cobra Jet. The Cobra Jet (429CJ) was fitted with a Rochester Quadrajet 715 cu ft/min (20.2 m 3 /min) Spreadbore 4-bbl carburetor, a larger camshaft; a special set of cylinder heads (DOOE-R) 73.5 CC, combustion chamber and canted valve ...
The 1994 Cobra was introduced midway through the model year with the same engine as the 1993 Cobra. With its GT-40 cast-iron heads and lower intake and its Cobra-specific upper intake, [1]: 36 power increased to 240 hp (179 kW; 243 PS). [1]: 34 However, the actual output of the Cobra's GT-40 enhanced engine was probably higher.
The Mustang's engine compartment was not wide enough to accommodate the massive Boss 429 engine, so Ford contracted with Kar Kraft of Dearborn, Michigan, to modify 4-speed Cobra Jet Mustangs to accept it. Kar Kraft was a Ford exclusive experimental facility that functioned as Vehicle Engineering for Ford's Special Vehicles.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
[3] [4] Marketing literature referred to this engine as the "Cobra hi-riser" due to its high-rise intake manifold. Beginning as a stock Mustang with a 4-speed manual transmission and 9-inch live rear axle, the cars were shipped to Shelby American, where they received the high-rise manifolds, Tri-Y headers, and were given larger Ford Galaxie ...
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines.