Search results
Results From The WOW.Com Content Network
There are also 3-in-1 car seats that can first be used as a rear-facing baby car seat, then as a forward-facing seat, then finally as a booster seat when the child reaches the recommended height and weight. [16] Unlike many booster seats, 3-1 car seats may use the LATCH system to be secured inside the car.
Seats are secured with a single attachment at the top (top tether) and two attachments at the base of each side of the seat. The full set of anchor points for this system were required in new cars in the United States starting in September 2002. In the EU the system is known as Isofix and covers both Group 0/0+ and Group 1 child safety seats ...
An anti-intrusion bar or beam is a passive safety device, installed in most cars and other ground vehicles, which must protect passengers from side impacts. [1] Side impacts are particularly dangerous for two reasons: a) the location of impact is very close to the passenger, who can be immediately reached by the impacting vehicle; b) in many side-impact accidents, the impacting vehicle may be ...
The bar may lower ground clearance by as much as 30 millimeters on some aftermarket installations. Lower tie bar (in stainless) attached to a rear subframe. The lower tie bar is mostly an aftermarket car component. Some of the few exceptions to this rule are the Honda Integra and Civic Type-R, as well as the Daihatsu Charade GTti.
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
A sissy bar (highlighted) mounted on a Harley-Davidson Dyna A sissy bar mounted on a Schwinn Sting-Ray. A sissy bar, also called a "sister bar" or "passenger backrest", is an addition to the rear of a bicycle or motorcycle that allows the rider or passenger to recline against it while riding. Alternatively it can serve as an anchor point or ...
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.
The brace procedure for the forward-facing seat in the United States is similar to that of the UK, but rather than placing the hands on the back of the head, passengers are advised to place them on the top of the seat in front, one hand holding the other wrist and resting the head in the space between the arms.