Ads
related to: digi key cross reference 50
Search results
Results From The WOW.Com Content Network
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
DigiKey is the fourth largest electronic component distributor in North America and the fifth largest electronic component distributor overall. [3] Stordahl privately owns the company . [4] The name "Digi-Key" is a reference to the "Digi-Keyer Kit," a digital electronic keyer kit that Stordahl developed and marketed to amateur radio enthusiasts.
The result is a reasonable tolerance (0.5%, 1%, or 2%) and a temperature coefficient that is generally between 50 and 100 ppm/K. [9] Metal film resistors possess good noise characteristics and low non-linearity due to a low voltage coefficient. They are also beneficial due to long-term stability.
Ronald Arthur Stordahl is the founder of electronic component distributor Digi-Key Electronics, located in Thief River Falls, Minnesota. [1] He previously served as chief executive officer but is now member of the board.
ITU-T recommendation T.50 specifies the International Reference Alphabet (IRA), formerly International Alphabet No. 5 (IA5), a character encoding. ASCII is the U.S. variant of that character set. The original version from November 1988 corresponds to ISO 646 .
Sun Microsystems and Data General used a 50-pin 3-row DD-50 connector, which was sometimes incorrectly called a "DB-50" or "HDB-50". Sun also used DB-25s on a few products. Digital Equipment Corporation mostly used the CN-50, but the VAXstation 3100 and DECstation 3100/2100 made use of a MALE 68-pin connector on the rear of the workstation ...
A bias tee is a three-port network used for setting the DC bias point of some electronic components without disturbing other components. The bias tee is a diplexer.The low-frequency port is used to set the bias; the high-frequency port passes the radio-frequency signals but blocks the biasing levels; the combined port connects to the device, which sees both the bias and RF.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]