Search results
Results From The WOW.Com Content Network
In effect, the formula reduces the legal weight limit for shorter trucks with fewer axles (see table below). For example, a 25-foot (7.6 m) three-axle dump truck would have a gross weight limit of 54,500 pounds (24,700 kg), instead of 80,000 pounds (36,000 kg), which is the standard weight limit for 63-foot (19.2 m) five-axle tractor-trailer. [1]
When stocking, a tree's basal area is measured. The basal area is a cross-sectional area of the stump taken about 4.5 feet (1.4 m) above the ground. [7] The equation for calculating the basal area of trees in a stand is Basal Area = 0.005454 DBH 2, where DBH is the diameter of the tree at the aforementioned measuring height. [7]
Overlength limits vary depending on the type and the configuration of vehicle, but the overall maximum forward distance (i.e. the length from the front of the vehicle to the centre axis of the rear axle set) is 9.5 m (31 ft 2 in), the overall maximum single vehicle length is 12.6 m (41 ft 4 in) (some buses can be longer), and the overall ...
square foot: sqft (ft2, sqfoot, foot2) Q857027: sq ft long code "sqfoot (foot2)" outputs square foot (and never feet) 1.0 ...
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
Railcars in the former BMT and IND can be longer: on the former Eastern Division, the cars are limited to 60 feet (18.29 m), while on the rest of the BMT and IND lines plus the Staten Island Railway (which uses modified IND stock) the cars may be as long as 75 feet (22.86 m). [39] [40]
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [1] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc.