Search results
Results From The WOW.Com Content Network
The International Harvester Company (IHC) has been building its own proprietary truck engines since the introduction of their first truck in 1907. International tended to use proprietary diesel engines. In the 1970s, IHC built the DVT 573 V-8 diesel of 240 and 260 hp (179 and 194 kW) but these were not highly regarded and relatively few were sold.
Engine displacement was 152 cubic inches (2,490 cc). The 504 had a broader range of features and options than the 404, with the same power steering and three-point hitch. A high-clearance version was produced, as well as the IH 504 utility tractor and the IH 2504 industrial tractor. [4] [5] [6] About 3,000 404s were produced, selling for about ...
[3] [4] The M was one of the most-widely produced of International Harvester's "letter series", with 270,140 produced over the 13-year run. The M was equipped with an International Harvester C248 inline overhead valve four-cylinder engine with a 248-cubic-inch (4,060-cubic-centimetre) displacement, and a six-volt electrical system.
The Farmall A is equipped with the F-14's International Harvester C113 4-cylinder inline overhead valve engine, with a 113-cubic-inch (1,850-cubic-centimetre) displacement. The transmission contains five total gears in a sliding gear arrangement: four forward and one reverse, transmitted to a portal axle. The A featured a wide front wheel track ...
Styled by Raymond Loewy, [1] [2] it was one of International Harvester's "letter series", replacing the Farmall F-20.The H was rated for two 14-inch (36 cm) plows. [3]The H is equipped with a 4-cylinder in-line overhead valve with a 152-cubic-inch (2,490-cubic-centimetre) displacement and a 6-volt, positive ground electrical system with generator, (when so ordered or retrofitted).
The Cub was initially designated the Farmall X, and was to use a two-cylinder engine. [1] Development started in July, 1943, changing to a four-cylinder engine. A prototype was built by December 1944. In September 1945, it became the Farmall Cub. [2] The two major variations of the Cub were the "Standard Cub" and the "Lo-Boy Cub" (or "Cub Lo-Boy").
The F5 wrecker [51] with a lack of 4×4 2 + 1 ⁄ 2 ton trucks available because of the Vietnam War, the Mk3 was supplemented with further 4×4 production with the updated Mk4 version [52] which shared the cab with the 6×6 variants Production of The Australian No.1. range of trucks were produced until 1973. The Mk3, Mk4, F1, F2 and F5 saw ...
The first D-line models were the DLD2, with a two-cylinder 12-horsepower (8.9 kW) engine, the DED3, with a three-cylinder 20-horsepower (15 kW) engine, and the DGD4, with a four-cylinder 30-horsepower (22 kW) engine, all diesels. [1] The second-generation D-line offered a more diverse range of products, some marketed under the Farmall brand.