Search results
Results From The WOW.Com Content Network
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Sump pumps are used where basement flooding may otherwise happen, and to solve dampness where the water table is near or above the foundation of a structure. Sump pumps send water away from a location to any place where it is no longer problematic, such as a municipal storm drain, a dry well, or simply an open-air site downhill from the building (sometimes called "pumping to daylight").
U.S. Navy submarine USS Greeneville in a graving dock A US Navy littoral combat ship in drydock, NASSCO 2012. A dry dock (sometimes drydock or dry-dock) is a narrow basin or vessel that can be flooded to allow a load to be floated in, then drained to allow that load to come to rest on a dry platform.
Although the pumps could not keep up with the floodwater, tools that had been used by the Onslow and Truro companies were recovered. [19] The Oak Island Association also did some work at Smith's Cove by drilling a few shafts in an attempt to shut off and seal the alleged flood tunnels.
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
A means had to be provided, of course, to put the initial charge of water into the boiler (before steam power was available to operate the steam-powered feedwater pump). The pump was often a positive displacement pump that had steam valves and cylinders at one end and feedwater cylinders at the other end; no crankshaft was required.
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
A pump-jet works by having an intake (usually at the bottom of the hull) that allows water to pass underneath the vessel into the engines. Water enters the pump through this inlet. The pump can be of a centrifugal design for high speeds, or an axial flow pump for low to medium speeds. The water pressure inside the inlet is increased by the pump ...