Search results
Results From The WOW.Com Content Network
Honeypot (computing) involves setting up a computer on a network just to see who comes along and does something on the open access point. Disabling SSID broadcasts has been recommended in the past as a security measure, although it only hides networks superficially. MAC addresses of routers are still broadcast, and can be detected using special ...
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...
In IEEE 802.11 wireless local area networking standards (including Wi‑Fi), a service set is a group of wireless network devices which share a service set identifier (SSID)—typically the natural language label that users see as a network name. (For example, all of the devices that together form and use a Wi‑Fi network called "Foo" are a ...
When users chooses to hide the network name from the router's setup page, it will only set the SSID in the beacon frame to null, but there are four other ways that the SSID is transmitted. In fact, hiding broadcast of the SSID on the router may cause the Network interface controller (NIC) to constantly disclose the SSID, even when out of range. [2]
Wi-Fi Protected Setup allows access points to be set up simply by entering a PIN or other identification into a connection screen, or in some cases, simply by pressing a button. The Protected Setup system uses this information to send data to a computer, handing it the information needed to complete the network setup and connect to the Internet.
In non-promiscuous mode, when a NIC receives a frame, it drops it unless the frame is addressed to that NIC's MAC address or is a broadcast or multicast addressed frame. In promiscuous mode, however, the NIC allows all frames through, thus allowing the computer to read frames intended for other machines or network devices.
Wireless speakers operate as receivers. The transmitter is a preamplifier that may be integrated in another device. Some wireless speakers use the 2.4 GHz band, with a proprietary protocol. They may be subject to dropouts caused by interference from other devices.
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...