Search results
Results From The WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
For a price much lower than a fully managed switch they provide a web interface (and usually no CLI access) and allow configuration of basic settings, such as VLANs, port-bandwidth and duplex. [29] [28] Enterprise managed switches (aka managed switches) have a full set of management features, including CLI, SNMP agent, and web interface. They ...
ifconfig (short for interface config) is a system administration utility in Unix-like operating systems for network interface configuration. The utility is a command-line interface tool and is also used in the system startup scripts of many operating systems. It has features for configuring, controlling, and querying TCP/IP network interface ...
"Global configuration mode" provides commands to change the system's configuration, and "interface configuration mode" provides commands to change the configuration of a specific interface. All commands are assigned a privilege level, from 0 to 15, and can only be accessed by users with the necessary privilege. Through the CLI, the commands ...
Initially, the SCSI Parallel Interface (SPI) was the only interface using the SCSI protocol. Its standardization started as a single-ended 8-bit bus in 1986, transferring up to 5 MB/s, and evolved into a low-voltage differential 16-bit bus capable of up to 320 MB/s.
Modes for the Linux bonding driver [14] (network interface aggregation modes) are supplied as parameters to the kernel bonding module at load time. They may be given as command-line arguments to the insmod or modprobe commands, but are usually specified in a Linux distribution-specific configuration file. The behavior of the single logical ...
This is a list of POSIX (Portable Operating System Interface) commands as specified by IEEE Std 1003.1-2024, which is part of the Single UNIX Specification (SUS). These commands can be found on Unix operating systems and most Unix-like operating systems.
Stack-level views and commands can be provided from a single command line interface (CLI) and/or embedded Web interface. The SNMP view into the stack can be unified. Stacking resiliency. Multiple switches can have ways to bypass a “down” switch in a stack, thus allowing the remaining units to function as a stack even with a failed or ...