Ads
related to: clevite connecting rod bearings for f134 dodge charger 3 5 alternator rebuild kit
Search results
Results From The WOW.Com Content Network
Clevite won defense contracts for some of its products and opened a new ordnance plant in 1967. [3] Clevite purchased Shockley Semiconductor Laboratory in 1960 and continued operating it until selling it (again to ITT as it had done with Intermetall) in 1968. In 1969, Clevite was acquired by Gould-National Batteries, [4] a firm one-quarter its ...
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
The crankpin connects to the larger end of the connecting rod for each cylinder. This end of the connecting rod is called the "big end", as opposed to the "small end" or "little end" (which connects to the wrist/gudgeon pin in the piston). The bearing which allows the crankpin to rotate around its shaft is called the "rod bearing". [5]
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
The L134 Go Devil was updated with the F-head to become the F134 in 1950. [4] [5] This engine produced a gross output of 75 hp (56 kW; 76 PS) at 4000 rpm and 114 lb⋅ft (155 N⋅m) of torque at 2000 rpm with a 7.5:1 compression ratio. The gross power and torque outputs decreased to 72 hp (54 kW; 73 PS) and 112 lb⋅ft (152 N⋅m), respectively ...
The crankshaft and connecting-rod big-end bearings in current automobile engines are made of a replaceable steel shell, keyed to the bearing caps. The inner surface of the steel shell is plated with a coating of bronze , which is in turn coated with a thin layer of Babbitt metal as the bearing surface.