Ads
related to: 5 lever mortice lock sizes guide chart printableamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock). The Chubb detector lock is a variation of the lever lock which was designed to detect and prevent picking attempts.
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
The normal key on the left will open only the lock that it goes to, but the skeleton key on the right will open any lock with this particular keyhole. Two warded lock keys and a homemade skeleton key A skeleton key (also known as a passkey [ 1 ] ) is a type of master key in which the serrated edge has been removed in such a way that it can open ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 16 January 2025. Device to open or close door Various examples of door handles throughout history A door handle or doorknob is a handle used to open or close a door. Door handles can be found on all types of doors including: exterior doors of residential and commercial buildings, internal doors, cupboard ...
The lock housing is the part of the lock that does not move when the lock is opened. It is responsible for transferring the action of the key to the bolt. [7] Master pin In a pin tumbler lock, a master pin is an optional, usually short, disk-like pin placed between the top and bottom pins. Its purpose is to allow two differently-cut keys to ...
The bitting is usually a series of integers (e.g. 372164) that is usually translated from a key code chart or from a bitting code list to settings on specially designed key machines. In many code systems each digit in the bitting corresponds to a certain location on the key blank where a cut or notch is to be made and also indicates the ...