Search results
Results From The WOW.Com Content Network
Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal) A well with 5,000 feet of seawater and 15,000 feet of rock could have an overburden pressures at the bottom as high as 17,220 psi (5000 * 0.444 ...
Some unit codes are not intended to be used in a template, but are needed to define exceptions. For example, the code ft has link Foot (unit), but unit psi/ft needs ft to be linked to Fracture gradient. To handle such cases, a unit code starting with "-" is used (-ft-frac for feet with a link to fracture gradient).
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
See WP:MOSNUM#Unit names and the discussion, and see Pound-foot (torque) and Foot-pound (energy). However, some topics use traditional units that conflict with the above convention. To handle these, Module:Convert/makeunits includes a specials table that adds an "alttype" (alternate type) field to certain whitelisted units.
The pressure gradient is defined only at these spatial scales at which pressure (more generally fluid dynamics) itself is defined. Within planetary atmospheres (including the Earth's ), the pressure gradient is a vector pointing roughly downwards, because the pressure changes most rapidly vertically, increasing downwards (see vertical pressure ...
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
The psi-potential is also frequently called the "datum pressure", since the function represents the pressure at any point in the reservoir after being transferred to the datum plane / depth z 0. In practical engineering work it is very useful to refer pressures measured in wells to a datum level or to map the distribution of datum pressures ...
HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To convert these units to SI units, one can use: 1 ppg ≈ 119.826 ...