Search results
Results From The WOW.Com Content Network
In 1951, the engines received 4-valve cylinder heads, thus creating Mark II "RK" and "V" types which ran at 750-850rpm. Intercooling became an option in 1960, adding a "C" to the engine designation should it be equipped. More revisions saw the creation of the Mark III engines in 1962.
International Journal of Engine Research. 12 (3): 209– 226. doi: 10.1177/1468087411401548. Reitz, Rolf D.; Duraisamy, Ganesh (February 2015). "Review of high efficiency and clean reactivity controlled compression ignition (RCCI) combustion in internal combustion engines". Progress in Energy and Combustion Science. 46: 12– 71.
The High-Speed Internal Combustion Engine. Singal, R.K. Internal Combustion Engines. New Delhi, India: Kataria Books. ISBN 978-93-5014-214-1. Stone, Richard (1992). Introduction to Internal Combustion Engines (2nd ed.). Macmillan. ISBN 978-0-333-55083-0. Yamagata, H. (2005). The Science and Technology of Materials in Automotive Engines ...
The efficiency of internal combustion engines depends on several factors, the most important of which is the expansion ratio. For any heat engine the work which can be extracted from it is proportional to the difference between the starting pressure and the ending pressure during the expansion phase. Hence, increasing the starting pressure is ...
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
For jet engine forms of internal combustion engines, a propelling nozzle is present. This takes the high temperature, high pressure exhaust and expands and cools it. The exhaust leaves the nozzle going at much higher speed and provides thrust, as well as constricting the flow from the engine and raising the pressure in the rest of the engine ...
Ward Leonard control, also known as the Ward Leonard drive system, was a widely used DC motor speed control system introduced by Harry Ward Leonard in 1891. In the early 1900s, the control system of Ward Leonard was adopted by the U.S. Navy and also used in passenger lifts of large mines.
In the early years, steam engines and electric motors were tried, but with limited success. In the 20th century, the internal combustion engine (ICE), became dominant. In 2015, the internal combustion engine remains the most widely used but a resurgence of electricity seems likely because of increasing concern about ic engine exhaust gas emissions.