Search results
Results From The WOW.Com Content Network
A Scientific Industries Inc. Vortex-Genie 2 vortex mixer in operation A vortex mixer , or vortexer , is a simple device used commonly in laboratories to mix small vials of liquid. It consists of an electric motor with the drive shaft oriented vertically and attached to a cupped rubber piece mounted slightly off-center.
Typical lectromechanical Universal Testing Machine Test fixture for three point flex test. A universal testing machine (UTM), also known as a universal tester, [1] universal tensile machine, materials testing machine, materials test frame, is used to test the tensile strength (pulling) and compressive strength (pushing), flexural strength, bending, shear, hardness, and torsion testing ...
The vortex tube, also known as the Ranque-Hilsch vortex tube, is a mechanical device that separates a compressed gas into hot and cold streams. The gas emerging from the hot end can reach temperatures of 200 °C (390 °F), and the gas emerging from the cold end can reach −50 °C (−60 °F). [ 1 ]
Strength tester may refer to: Grippers , a device used for testing and increasing the strength of the hands High striker , a attraction that operates by utilizing the lever where one end holds a puck attached to the tower and the other end is struck by the person or contestant using a hammer or mallet
Continuous vortex sheet approximation by panel method. Roll-up of a vortex sheet due to an initial sinusoidal perturbation. Note that the integral in the above equation is a Cauchy principal value integral. The initial condition for a flat vortex sheet with constant strength is (,) =. The flat vortex sheet is an equilibrium solution.
MDT – modular formation dynamic tester, a tool used to get formation pressure in the hole (not borehole pressure which the PWD does). MDT could be run on Wireline or on the Drill Pipe MDR – mud damage removal (acid bullheading)
Applying the glue automatically and curing with UV light is the next step in automation. This methodology can also be used to measure direct tensile strength or/and the bond strength between two different layers. MIL-STD-883 methods 2011.9 destructive bond pull test [1] and 2031.1 flip chip pull off test [2] apply, as well as JEDEC JESD22-B109.
The starting vortex is significant to an understanding of the Kutta condition and its role in the circulation around any airfoil generating lift. The starting vortex has certain similarities with the "starting plume" which forms at the leading edge of a slug of fluid, when one fluid is injected into another at rest. See plume (hydrodynamics).