Ads
related to: ridge beam and rafter system for construction buildings cost list
Search results
Results From The WOW.Com Content Network
The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths , battens , or purlins are fixed to the rafters; or boards, plywood , or oriented strand board form the roof deck (also called the sheeting or ...
Butterfly roof (V-roof, [8] London roof [9]): A V-shaped roof resembling an open book. A kink separates the roof into two parts running towards each other at an obtuse angle. Karahafu: A type of gable found in some traditional Japanese buildings. Hidden roof: A type of Japanese roof construction.
Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam. King rafter: the longest rafter on the side of a hip roof in line with the ridge. Valley rafter (historically also called a sleeper): A rafter forming a valley (look for illustration showing a valley). Intermediate rafter: "one ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
The term binding joist is sometimes used to describe beams at floor level running perpendicular to the ridge of a gable roof and joined to the intermediate posts. Joists which land on a binding joist are called bridging joists. [4] [5] A large beam in the ceiling of a room carrying joists is a summer beam. A ceiling joist may be installed flush ...