Ads
related to: toilet cistern will not flush drain tank video clips
Search results
Results From The WOW.Com Content Network
The lever arm connecting the siphon plate to the flush chain was often fixed directly to a pivot on the siphon rather than the cistern, so the arrangement of the siphons was highly flexible: flush pipes could be fitted in the middle or side of the cubicles; flush chains could be arranged at the back or front of the trough, or through the bottom ...
A typical flush toilet is a fixed, vitreous ceramic bowl (also known as a pan) which is connected to a drain. After use, the bowl is emptied and cleaned by the rapid flow of water into the bowl. This flush may flow from a dedicated tank (cistern), a high-pressure water pipe controlled by a flush valve, or by manually pouring water into the bowl.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
A flushing trough is a type of cistern used to serve more than one WC pan at one time. These cisterns are becoming less common, however. The cistern was the genesis of the modern bidet. [citation needed] At the beginning of the flush cycle, as the water level in the toilet cistern tank drops, the flush valve flapper falls back to the bottom ...
A dry toilet (or non-flush toilet, no flush toilet or toilet without a flush) is a toilet which, unlike a flush toilet, does not use flush water. [20] Dry toilets do not use water to move excreta along or block odors. [21] They do not produce sewage, and are not connected to a sewer system or septic tank. Instead, excreta falls through a drop ...
Squat toilet (flush toilet) with water cistern for flushing (Cape Town, South Africa) A squat toilet (or squatting toilet) is a toilet used by squatting, rather than sitting. This means that the posture for defecation and for female urination is to place one foot on each side of the toilet drain or hole and to squat over it.
Some toilets also use the siphon principle to obtain the actual flush from the cistern. The flush is triggered by a lever or handle that operates a simple diaphragm-like piston pump that lifts enough water to the crest of the siphon to start the flow of water which then completely empties the contents of the cistern into the toilet bowl.
Pour-flush pit latrine schematic showing squatting pan with water seal. In a pour-flush pit latrine, a squatting or pedestal toilet with a water seal (U-trap or siphon) is used over one or two offset pits. These types of toilets do require water for flushing but otherwise share many of the same characteristics as simple pit latrines.