Ads
related to: rear axle gears
Search results
Results From The WOW.Com Content Network
An epicyclic differential uses epicyclic gearing to send certain proportions of torque to the front axle and the rear axle in an all-wheel drive vehicle. [citation needed] An advantage of the epicyclic design is that it is relatively compact width (when viewed along the axis of its input shaft). [citation needed]
Distinguishing it from the GM 14-bolt 9.5-inch ring gear rear differential is the latter's utilization of C-clips to retain axles, differing from the free-floating axle mechanism of its heavy-duty counterpart.
All Dana 70 rear axles are full floating and typically have a gross axle rating of 7,500 lb (3,400 kg). The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts.
The Dana 44 rear axle first saw use in the 1940s and is still in use today. The Dana 44 has a GAWR up to 3,500 lb (1,600 kg) and is a semi-floating type, having one bearing on the end of the axle shaft which carries the weight of the vehicle on the axle and also allows axle rotation.
Its design is similar to the Torsen T-2 (slightly less torque bias), and is an aftermarket part for many popular US-made solid axles for rear-wheel drive and 4x4 pick-up trucks. The Truetrac is most often used in the front axle of 4x4 pick-up trucks intended for off-road use, in combination with locking center and rear differentials.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
Ad
related to: rear axle gears