Search results
Results From The WOW.Com Content Network
Fault detection coverage that system built-in test will realize; Whether the analysis will be functional or piece-part; Criteria to be considered (mission abort, safety, maintenance, etc.) System for uniquely identifying parts or functions; Severity category definitions
Comparing signatures quantitatively using principal component analysis allows for the spread of signature images, enabling faults to be detected [14] and identified [15] The system includes algorithms and mathematics appropriate for real-time welding analysis on personal computers, and the multidimensional optimization of fault-detection ...
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
It should be based on hardware breakdown (e.g. the BoM = bill of materials). Any failure effect severity, failure prevention (mitigation), failure detection and diagnostics may be fully analyzed in this FMEA. Process: analysis of manufacturing and assembly processes. Both quality and reliability may be affected from process faults.
Failure analysis is the process of collecting and analyzing data to determine the cause of a failure, often with the goal of determining corrective actions or liability.. According to Bloch and Geitner, ”machinery failures reveal a reaction chain of cause and effect… usually a deficiency commonly referred to as the symptom…”
Fault reporting is an optional feature that can be forwarded to remote displays using simple configuration setting in all modern computing equipment. The system level of reporting that is appropriate for Condition Based Maintenance are critical, alert, and emergency, which indicate software termination due to failure.
When adding equipment is impractical (usually because of expense), then the least expensive form of design is often "inherently fail-safe". That is, change the system design so its failure modes are not catastrophic. Inherent fail-safes are common in medical equipment, traffic and railway signals, communications equipment, and safety equipment.
No fault found (NFF), no trouble found (NTF) or no defect found (NDF) are terms used in the field of maintenance, where a unit is removed from service following a complaint of a perceived fault by operators or an alarm from its BIT (built-in test) equipment. The unit is then checked, but no anomaly is detected by the maintainer.