Search results
Results From The WOW.Com Content Network
A radio transmitter design has to meet certain requirements. These include the frequency of operation, the type of modulation, the stability and purity of the resulting signal, the efficiency of power use, and the power level required to meet the system design objectives. [1]
4×4 array of 2.4 GHz patch antenna elements Patch antenna gain pattern. A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane.
The open-loop gain is a physical attribute of an operational amplifier that is often finite in comparison to the ideal gain. While open-loop gain is the gain when there is no feedback in a circuit, an operational amplifier will often be configured to use a feedback configuration such that its gain will be controlled by the feedback circuit components.
A low-noise amplifier (LNA) is an electronic component that amplifies a very low-power signal without significantly degrading its signal-to-noise ratio (SNR). Any electronic amplifier will increase the power of both the signal and the noise present at its input, but the amplifier will also introduce some additional noise.
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The triode vacuum tube amplifiers of the day would not amplify stably above 500 kHz; however, it was easy to get them to oscillate above that frequency. Armstrong's solution was to set up an oscillator tube that would create a frequency near the incoming signal and mix it with the incoming signal in a mixer tube, creating a heterodyne or signal ...
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
The idea is to find how much the amplifier gain is changed because of the resistors in the feedback network by themselves, with the feedback turned off. This calculation is pretty easy because R 11, R B, and r π1 all are in parallel and v 1 = v π. Let R 1 = R 11 || R B || r π1. In addition, i 2 = −(β+1) i B. The result for the open-loop ...