Ad
related to: understanding subnetting easy way
Search results
Results From The WOW.Com Content Network
Creating a subnet by dividing the host identifier. A subnetwork, or subnet, is a logical subdivision of an IP network. [1]: 1, 16 The practice of dividing a network into two or more networks is called subnetting. Computers that belong to the same subnet are addressed with an identical group of its most-significant bits of their IP addresses.
There are several different non-equivalent definitions of "subnet" and this article will use the definition introduced in 1970 by Stephen Willard, [1] which is as follows: If = and = are nets in a set from directed sets and , respectively, then is said to be a subnet of (in the sense of Willard or a Willard–subnet [1]) if there exists a monotone final function: such that = ().
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
Interior Gateway Routing Protocol, Exterior Gateway Protocol and version 1 of the Routing Information Protocol (RIPv1) assume classful addressing, and therefore cannot transmit the subnet mask information required for supernetting. Enhanced Interior Gateway Routing Protocol (EIGRP) supports CIDR. By default, EIGRP summarizes the routes within ...
As shown in the example below, in order to calculate the directed broadcast address to transmit a packet to an entire IPv4 subnet using the private IP address space 172.16.0.0 / 12, which has the subnet mask 255.240.0.0, the broadcast address is calculated as 172.16.0.0 bitwise ORed with 0.15.255.255 = 172.31.255.255. Directed broadcasts always ...
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
network identifier: The destination subnet and netmask; metric: The routing metric of the path through which the packet is to be sent. The route will go in the direction of the gateway with the lowest metric. next hop: The next hop, or gateway, is the address of the next station to which the packet is to be sent on the way to its final destination
It included the ability to carry subnet information, thus supporting Classless Inter-Domain Routing (CIDR). To maintain backward compatibility, the hop count limit of 15 remained. RIPv2 has facilities to fully interoperate with the earlier specification if all Must Be Zero protocol fields in the RIPv1 messages are properly specified.