Ads
related to: why replace strut mounts
Search results
Results From The WOW.Com Content Network
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
The axis of the strut may be angled inwards from the steering axis at the bottom, to clear the tyre, which makes the bottom follow an arc when steering. The MacPherson strut benefited from introduction of unibody construction, because its design requires substantial vertical space and a strong top mount, which unibody construction can provide.
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
Strut is a common name in timber framing for a support or brace of scantlings lighter than a post. Frequently struts are found in roof framing from either a tie beam or a king post to a principal rafter. Struts may be vertically plumb or leaning (then called canted, raking, or angled) and may be straight or curved.
Oleo strut - design used in most large aircraft, with compressed gas and hydraulic fluid - conceptually similar to automobile Hydropneumatic suspension; Scrub radius; Short long arms suspension — also known as "unequal length A arm", one of the design parameters of double wishbone suspension; Strut bar — a part to make a suspension setup ...
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...