Ads
related to: fiskars large heavy punch blade attachmentuline.com has been visited by 1M+ users in the past month
- Slice® Box Cutters
Knife like no other. Circular
handle with soft rubber grip.
- Deluxe Klever Cutters
Single & dual sided.
Thick, recessed carbon steel blade.
- Slice® Pen Cutters
Cuts through tape, cartons &
twine. Includes 1 blade.
- Klever Koncept™ Cutters
Reduce employee injuries and
damage to merchandise.
- Slice® Box Cutters
Search results
Results From The WOW.Com Content Network
Gerber Legendary Blades is an American maker of knives, multitools, and other tools for outdoors and military headquartered in Portland, Oregon. Gerber is owned by the Finnish outdoors products company Fiskars. Gerber was established in 1939 by Pete Gerber. Gerber is the "largest maker of knives and multi-tools for the United States armed forces."
A push dagger (alternately known as a punch dagger, punch knife, push knife or, less often, a push dirk) is a short-bladed dagger with a "T" handle designed to be grasped and held in a closed-fist hand so that the blade protrudes from the front of the fist, either between the index and middle fingers or between the two central fingers, when the grip and blade are symmetrical.
Fiskars Corporation (natively Fiskars Oyj Abp; formerly Fiskars Oy Ab until 1998) [3] is a Finnish consumer goods company founded in 1649 in Fiskars, a locality now in the town of Raseborg, Finland, about 100 kilometres (62 mi) west of Helsinki. It is one of the oldest continuously operating companies in the world.
A pair of tonfa A pair of tonfa with a rounded body throughout.. The tonfa (Okinawan: トンファー tonfā, Chinese: 柺; pinyin: guǎi lit. old man's staff / "crutch", also spelled as tongfa or tuifa, also known as T-baton [1]) is a melee weapon with its origins in the armed component of Okinawan martial arts where it is known as the tunkua.
A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]
To use the punch down tool, a wire is pre-positioned into a slotted post on a punch block, and then the punch down tool is pressed down on top of the wire, over the post. Once the required pressure is reached, an internal spring is triggered, and the blade pushes the wire into the slot, simultaneously cutting the insulation and securing the ...
Ad
related to: fiskars large heavy punch blade attachmentuline.com has been visited by 1M+ users in the past month