Ads
related to: creative homemade go-kart steering linkage
Search results
Results From The WOW.Com Content Network
When I was a child, I had a pedal-powered go-cart that used steering as described here, where the steering column operates the Pitman arm directly. That's about the biggest vehicle that can work in this way - any bigger needs a steering box of some form, which has a geared mechanical advantage and often also makes the steering action non ...
Steering system showing drag link. A drag link converts rotary motion from a crank arm, to a second bellcrank, usually in an automotive steering system.. While the origin of the term is not clear, it pre-dates the automobile, and is described as in use in 1849 as a means of rotating a Ducie cultivator being operated by cable by stationary steam engine (or between engines).
A parallelogram steering linkage is called such because like its namesake, the two sides of the linkage run parallel to each other and are equal in distance. This type of steering linkage uses four tie rods, one inner and one outer on each side (left and right) that are connected by an adjustment sleeve, a center link (which runs between the tie rods), an idler arm on the passenger side, and a ...
The steering linkage which connects the steering gearbox to the front wheels consists of a number of rods. These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the ...
This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that the steering arms of the hubs appeared to "toe out". As the steering moved, the wheels turned according to Ackermann, with the inner wheel turning further. [3]
A steering column may also perform the following secondary functions: energy dissipation management in the event of a frontal collision; provide mounting for: the multi-function switch, column lock, column wiring, column shroud(s), transmission gear selector, gauges or other instruments as well as the electro motor and gear units found in EPAS and SbW systems;