Search results
Results From The WOW.Com Content Network
In some cases where the radius of the substitutional atom (ion) is substantially smaller than that of the atom (ion) it is replacing, its equilibrium position can be shifted away from the lattice site. These types of substitutional defects are often referred to as off-center ions. There are two different types of substitutional defects ...
The software development process is a typical application of Fagan inspection. As the costs to remedy a defect are up to 10 to 100 times less in the early operations compared to fixing a defect in the maintenance phase, [1] it is essential to find defects as close to the point of insertion as possible.
2.0 Overview of Software Reliability Growth (Estimation) Models Software reliability growth (or estimation) models use failure data from testing to forecast the failure rate or MTBF into the future. The models depend on the assumptions about the fault rate during testing which can either be increasing, peaking, decreasing or some combination of ...
Each inspector prepares for the meeting by reading the work product and noting each defect. In an inspection, a defect is any part of the work product that will keep an inspector from approving it. For example, if the team is inspecting a software requirements specification, each defect will be text in the document which an inspector disagrees ...
This graph is used in reliability engineering and deterioration modeling. The 'bathtub' refers to the shape of a line that curves up at both ends, similar in shape to a bathtub. The bathtub curve has 3 regions: The first region has a decreasing failure rate due to early failures. The middle region is a constant failure rate due to random failures.
The V-model is a graphical representation of a systems development lifecycle.It is used to produce rigorous development lifecycle models and project management models. The V-model falls into three broad categories, the German V-Modell, a general testing model, and the US government standard.
For example, the defect may result in an ion on its own ion site or a vacancy on the cation site. To complete the reactions, the proper number of each ion must be present (mass balance), an equal number of sites must exist (site balance), and the sums of the charges of the reactants and products must also be equal (charge balance).
Orthogonal defect classification (ODC) [1] turns semantic information in the software defect stream into a measurement on the process. [2] The ideas were developed in the late 1980s and early 1990s by Ram Chillarege [3] at IBM Research. This has led to the development of new analytical methods used for software development and test process ...