Search results
Results From The WOW.Com Content Network
The top-oiler block sent oil to the top center first, the side-oiler block sent oil along a passage located on the lower side of the block first. All FE and FT engines have a bore spacing of 4.630 in (117.6 mm), and a deck height (distance from crank center to top of block) of 10.170 in (258.3 mm).
Other than that, this engine is vastly different from the Gen-1 model. The Gen-1 engine is physically the size of a big-block Ford or GM engine, and is sometimes called a "big-block". The Gen-2 is closer to the physical size of U.S.-made small-block V8s except for the bore centers, which are the same as some big-block engines.
Even with the benefit of today's technology (aftermarket rods and stroker cranks), the upper limit of a Y-block is about 348 cu in (5.7 L), while the Chevrolet could be modified well past the factory limit of 400 cu in (6.6 L). The result was the introduction in 1958 of the 332 CID "big block" Ford FE engine which ultimately grew to 428 cu in.
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
A dog wanders up to the fenceleine at Jasper Animal Recue Mission along Carters Mill Road on Monday, Nov. 13, 2023 in Ridgeland, S.C. Drew Martin/dmartin@islandpacket.com
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
Champion spark plugs provided their dyno room. Towards the end of 1968, Kaplan enlisted help from Dan Byer, a retired engineer from AMC, to develop a new block casting. Using AMC 390 engineering drawings, they added more mass for four-bolt mains and improved the oiling system. A run of 50 blocks was contracted to Central Foundries in Windsor ...
The smallest-displacement engine of the 385 engine family, the 370 was introduced after the 429 and 460, replacing the 361 cu in (5.9 L) 360 Truck (FT) V8 in 1977. . Sharing its 3.59-inch stroke with the 429, the 370 was designed with a downsized 4.05-inch bore (shared with its predecessor and the 3