Search results
Results From The WOW.Com Content Network
Until the late 19th century, first-angle projection was the norm in North America as well as Europe; [7] [8] but circa the 1890s, third-angle projection spread throughout the North American engineering and manufacturing communities to the point of becoming a widely followed convention, [7] [8] and it was an ASA standard by the 1950s. [8]
On engineering drawings, the projection is denoted by an international symbol representing a truncated cone in either first-angle or third-angle projection, as shown by the diagram on the right. The 3D interpretation is a solid truncated cone, with the small end pointing toward the viewer.
Isometric projection is a method for visually representing three-dimensional objects in two dimensions in technical and engineering drawings. It is an axonometric projection in which the three coordinate axes appear equally foreshortened and the angle between any two of them is 120 degrees.
In both cases, the front or main side of the object is the same. First-angle is drawing the object sides based on where they land. Example, looking at the front side, rotate the object 90 degrees to the right. What is seen will be drawn to the right of the front side. Third-angle is drawing the object sides based on where they are.
Orthographic projection (also orthogonal projection and analemma) [a] is a means of representing three-dimensional objects in two dimensions.Orthographic projection is a form of parallel projection in which all the projection lines are orthogonal to the projection plane, [2] resulting in every plane of the scene appearing in affine transformation on the viewing surface.
A working drawing is a type of technical drawing, which is part of the documentation needed to build an engineering product or architecture. Typically in architecture these could include civil drawings , architectural drawings , structural drawings , mechanical drawings , electrical drawings , and plumbing drawings .
ISO 128-44:2001 Technical drawings — General principles of presentation — Part 44: Sections on mechanical engineering drawings ISO 128-50:2001 Technical drawings — General principles of presentation — Part 50: Basic conventions for representing areas on cuts and sections
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.