When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   The signal is a 1 kHz square wave at ±12 volts generated by the EVSE to detect the presence of the vehicle, communicate the maximum allowable charging current, and control charging begin/end. [ 21 ] ^ Top row is spaced 6.8 mm (0.27 in) above the centerline of the connector and the pins are spaced 15.7 mm (0.62 in) apart about the centerline.

3. Combined Charging System - Wikipedia

   en.wikipedia.org/wiki/Combined_Charging_System

   CCS1 (Combined Charging System Combo 1) plug as used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Incomplete Combo 2 (left) showing the two large direct current (DC) pins below, while the four alternating current (AC) pins for neutral and three-phase are removed, while ...

4. SAE J3068 - Wikipedia

   en.wikipedia.org/wiki/SAE_J3068

   The control protocol is a variation of LIN which retains the analog voltage level signaling from SAE J1772. The positive level of the LIN signal waveform can change from 12 volts to 9 or 6 volts (known as State A, State B, and State C in J1772). An earlier version of this LIN-based control protocol was published in Annex D of IEC 61851 edition 3.

5. Charging station - Wikipedia

   en.wikipedia.org/wiki/Charging_station

   AC Level 1: Connects directly to a standard 120 V North American outlet; capable of supplying 6–16 A (0.7–1.92 kilowatts or "kW") depending on the capacity of a dedicated circuit. AC Level 2 : Uses 240 V (single phase) or 208 V (three phase) power to supply between 6 and 80 A (1.4–19.2 kW).

6. North American Charging System - Wikipedia

   en.wikipedia.org/wiki/North_American_Charging_System

   The North American Charging System (NACS), standardized as SAE J3400, is an electric vehicle (EV) charging connector standard maintained by SAE International. [1] Developed by Tesla, Inc., it has been used by all North American market Tesla vehicles since 2021 and was opened for use by other manufacturers in November 2022.

7. Type 2 connector - Wikipedia

   en.wikipedia.org/wiki/Type_2_connector

   The IEC 62196 Type 1 connector (codified under SAE J1772) is the corresponding standard for single-phase AC charging in the United States, Canada, and South Korea. [8] J1772 has a maximum output of 19.2 kW. [9]

8. IEC 62196 - Wikipedia

   en.wikipedia.org/wiki/IEC_62196

   From left: IEC Type 1/SAE J1772 inlet; Tesla NACS outlet; IEC Type 2 connector outlet IEC 62196 Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles is a series of international standards that define requirements and tests for plugs, socket-outlets, vehicle connectors and vehicle inlets for conductive charging of electric vehicles and is ...

9. IEC 61851 - Wikipedia

   en.wikipedia.org/wiki/IEC_61851

   Typical public AC charger installation. Tethered (cable permanently attached) & untethered (dedicated socket outlet only) configurations. 3φ: 32A: 480V 4 EVSE rectifies AC grid & supplies DC power to EV using tethered cable with bidirectional communication – 200A: 400V DC, dedicated (IEC 62196-3) "fast DC" Current conversion handled by EVSE ...