Search results
Results From The WOW.Com Content Network
Wire removal is a visual effects technique used to remove wires in films, where the wires are originally included as a safety precaution or to simulate flying in actors or miniatures. It uses a lot of rotomatting, a process of using splines in a program like After Effects or Nuke to extract a subject from a video, motion tracking, and painting ...
Also referred to as Component video and YUV. D-Terminal uses voltage levels to signal resolution. Digital Visual Interface (DVI) 1999: DVI, Mini-DVI, Micro-DVI: Both: 2560 × 1600 @ 60 3840 × 2400 @ 33: Video cards: Almost a ubiquitous computer display link. Uncompressed video only. High-bandwidth Digital Content Protection (HDCP) encryption ...
A Fahnestock clip, showing how it grips a stripped wire. It can be released by pushing the tab down as shown. A Fahnestock clip is an early type of spring clamp electrical terminal for connections to bare wires. It is still [when?] used in educational electronic kits and teaching laboratories in schools. It is designed to grip a bare wire ...
FASTON terminals or faston terminals are connectors that are widely used in electronic and electrical equipment. These terminals are manufactured by many companies, commonly using the terms "quick disconnect", "quick connect", "tab" terminals, "spade" terminals [ 1 ] or blade connectors ; without qualifiers, the first two could be mistaken for ...
Although mini-DIN connectors are used for S-Video connections, composite video, component video, and analog audio (mono or stereo) all use RCA connectors unless the signals are sent via SCART. In the digital realm, however, combined A/V connectors are gaining ground; HDMI is commonly used today for consumer electronics, and DisplayPort , a ...
Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.
An optical network terminal (ONT, an ITU-T term), also known as an optical network unit (ONU, an IEEE term), is used to terminate the optical fiber line, demultiplex the signal into its component parts (voice telephone, television, and Internet access), and provide power to customer telephones.
The first "Cannon plug", the M-1 connector, was initially designed as a quick grounding connection for the electrical motor on a portable meat grinder and was adapted for movie sound equipment, enabling the new electrical camera to move freely about while “shooting” a scene.