Ad
related to: pin diagram of arduino board
Search results
Results From The WOW.Com Content Network
LED: There is a built-in LED driven by digital pin 13.When the pin is high value, the LED is on, when the pin is low, it is off. VIN: The input voltage to the Arduino/Genuino board when it is using an external power source (as opposed to 5 volts from the USB connection or other regulated power source).
An Arduino-compatible board that includes a Zigbee radio . The ZB1 can be powered by USB, a wall adapter or an external battery source. It is designed for low-cost Wireless sensor network applications. SunDuino2 [111] ATmega16/32/324/644 An open source enhanced Arduino-compatible board that uses an ATmega16/32/324/644 instead of an ATmega168.
Power LED (red) and User LED (green) attached to pin 13 on an Arduino-compatible board. Most Arduino boards contain a light-emitting diode (LED) and a current-limiting resistor connected between pin 13 and ground, which is a convenient feature for many tests and program functions. [76] A typical program used by beginners, akin to Hello, World!, is
The Arduino Nano is equipped with 30 male I/O headers, in a DIP-30-like configuration, which can be programmed using the Arduino Software integrated development environment (IDE), which is common to all Arduino boards and running both online and offline. The board can be powered through a type-B mini-USB cable or from a 9 V battery. [2]
The STK600 uses a base board, a signal routing board, and a target board. The base board is similar to the STK500, in that it provides a power supply, clock, in-system programming, an RS-232 port and a CAN (Controller Area Network, an automotive standard) port via DE9 connectors, and stake pins for all of the GPIO signals from the target device.
A general-purpose input/output (GPIO) is an uncommitted digital signal pin on an integrated circuit or electronic circuit (e.g. MCUs/MPUs) board which may be used as an input or output, or both, and is controllable by software. GPIOs have no predefined purpose and are unused by default.
The first Arduino board based on an ARM Processor. Features 2 channel 12-bit DAC, 84 MHz clock frequency, 32-bit architecture, 512 KB Flash and 96 KB SRAM. Unlike most Arduino boards, it operates on 3.3 V and is not 5 V tolerant. Arduino Yún [15] Arduino Yes ATmega32U4, [16] Atheros AR9331 16 MHz, 400 MHz Arduino
The BASIC Stamp is programmed in a variant of the BASIC language, called PBASIC. PBASIC incorporates common microcontroller functions, including PWM, serial communications, I²C and 1-Wire communications, communications with common LCD driver circuits, hobby servo pulse trains, pseudo-sine wave frequencies, and the ability to time an RC circuit which may be used to detect an analog value.