Search results
Results From The WOW.Com Content Network
A rule of thumb in determining if a reply fits into the 4xx or the 5xx (Permanent Negative) category is that replies are 4xx if the commands can be repeated without any change in command form or in properties of the User or Server (e.g., the command is spelled the same with the same arguments used; the user does not change his file access or ...
Below is a list of FTP commands that may be sent to a File Transfer Protocol (FTP) server. It includes all commands that are standardized by the Internet Engineering Task Force (IETF) in RFC 959, plus extensions. Note that most command-line FTP clients present their own non-standard set of commands to
One is that the FTP client and FTP server use the PASV command, which causes the data connection to be established from the FTP client to the server. [13] This is widely used by modern FTP clients. Another approach is for the NAT to alter the values of the PORT command, using an application-level gateway for this purpose.
SMB Server Message Block; SMPP Short Message Peer-to-Peer; SOCKS "SOCKetS" ZIP Zone Information Protocol {For AppleTalk} This layer provides session management capabilities between hosts. For example, if some host needs a password verification for access and if credentials are provided then for that session password verification does not happen ...
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
The term C10k was coined in 1999 by software engineer Dan Kegel, [3] [4] citing the Simtel FTP host, cdrom.com, serving 10,000 clients at once over 1 gigabit per second Ethernet in that year. [1] The term has since been used for the general issue of large number of clients, with similar numeronyms for larger number of connections, most recently ...
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
File eXchange Protocol (FXP or FXSP) is a method of data transfer which uses FTP to transfer data from one remote server to another (inter-server) without routing this data through the client's connection. Conventional FTP involves a single server and a single client; all data transmission is done between these two. In the FXP session, a client ...