Ads
related to: 30 amp inline fuse holder connector for rv refrigerator vent cover- Truck Parts & Accessories
Truck Parts & Accessories that Fit
Huge Selection and Great Prices.
- Tools & Equipment
Shop Automotive Tools & Equipment.
Deals on Thousands of Products
- Exterior Accessories
Shop Mirrors, Covers & More.
Huge Selection and Great Prices.
- RV Parts & Accessories
RV Parts & Accessories that Fit.
Save on RV Parts & Accessories.
- Interior Accessories
Shop Seat Covers, Mirrors & More.
Save on Parts & Accessories.
- Oil, Coolants & Fluids
Shop from your Favorite Brands.
Deals on Thousands of Products
- Truck Parts & Accessories
Search results
Results From The WOW.Com Content Network
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
PLASTI-GRIP (Vinyl) (insulation restricting) terminals are defined in AMP Specification 114-1003: Terminal, FASTON, PLASTI-GRIP, Application of; UL 310 "Standard for Electrical Quick-Connect Terminals" [4] CSA 22.2 #153, "Quick-Connect Terminals" UL 486 also specifies the testing of standard wire connectors and soldering lugs. MIL-T-7928
A variant of the Australian standard 10 amperes plug has a socket on the back to allow connection of a second appliance to the same outlet. This type of plug is known officially as a "socket adapter plug" but is referred to colloquially, in Australia, as a "piggy-back plug", or in New Zealand, as a "tap-on" plug and is shown below to the right.
[7]: 40 By definition, each end of this "adapter" has a different connection method – e.g. the solder tabs on a male phone connector, and the male phone connector itself. [3] In this example, the solder tabs connected to the cable represent the permanent connection, whilst the male connector portion interfaces with a female socket forming a ...