Search results
Results From The WOW.Com Content Network
A galvanostat (also known as amperostat) is a control and measuring device capable of keeping the current through an electrolytic cell in coulometric titrations constant, disregarding changes in the load itself. Its main feature is its nearly "infinite" (i.e. extremely high in respect to common loads) internal resistance.
In professionally built wire-wrap boards, long wires are placed first so that shorter wires mechanically secure the long wires. Also, to make an assembly more repairable, wires are applied in layers. The ends of each wire are always at the same height on the post, so that at most three wires need to be replaced to replace a wire.
The skin effect and proximity effect cause conductors to exhibit higher resistance to alternating current (AC) than to direct current (DC). Due to the dual inverse nature of the electromagnetic field, the skin effect dominates at frequencies less than about 2 MHz; at higher frequencies, the proximity effect becomes the dominant force, and Litz wire induces more DC losses than solid wire or ...
Superconducting wires are electrical wires made of superconductive material. When cooled below their transition temperatures , they have zero electrical resistance . Most commonly, conventional superconductors such as niobium–titanium are used, [ 1 ] but high-temperature superconductors such as YBCO are entering the market.
A potentiostat is a control and measuring device. It comprises an electric circuit which controls the potential across the cell by sensing changes in its resistance, varying accordingly the current supplied to the system: a higher resistance will result in a decreased current, while a lower resistance will result in an increased current, in order to keep the voltage constant as described by ...
Many D&S sockets were still in use until the early 1980s, although the difficulty in obtaining plugs for them after around 1970 often forced their users to replace them with BS 1363 sockets. The D&S plug suffered from a serious design fault: the line pin was a fuse which screwed into the plug body and tended to come unscrewed on its own in use.
Trolley pole wheel on top of the trolley pole of Twin City Rapid Transit Company No. 1300. A current collector (often called a "pickup") is a device used in trolleybuses, trams, electric locomotives and EMUs to carry electric power from overhead lines, electric third rails, or ground-level power supplies to the electrical equipment of the vehicles.
This practice arose from the three-wire system used to supply both 120 volt and 240 volt loads. Because these listed appliances often have components that use either 120, or both 120 and 240 volts, there is often some current on the neutral wire. This differs from the protective grounding wire, which only carries current under fault conditions.