When.com Web Search

  1. Ads

    related to: dana 35 c axle kit

Search results

  1. Results From The WOW.Com Content Network
  2. Dana 35 - Wikipedia

    en.wikipedia.org/wiki/Dana_35

    The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep

  3. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.

  4. American Motors Corporation - Wikipedia

    en.wikipedia.org/wiki/American_Motors_Corporation

    Axle tooling equipment – Sold in 1985 to Dana Holding Corporation, and they named the AMC-15 axles as Dana 35. [203] Dana manufactured the AMC-20 axles for AM General's Hummer H1. The company also continues to produce the AMC-15 axle; however, they have been upgraded from American Motors' original design with multiple variations (including ...

  5. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."

  6. Twin-Traction Beam - Wikipedia

    en.wikipedia.org/wiki/Twin-Traction_Beam

    The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.

  7. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.