Ads
related to: luer lock to connector adapter for generator to home gym wall
Search results
Results From The WOW.Com Content Network
A syringe with a male luer lock fitting, and a needle with female luer lock fitting (purple) which screws into it. The Luer taper is a standardized system of small-scale fluid fittings used for making leak-free connections between a male-taper fitting and its mating female part on medical and laboratory instruments, including hypodermic syringe tips and needles or stopcocks and needles.
Early generator interlock kits consisted of two sliding steel or plastic (depending on the brand) plates held together by three bolts and installed on the front cover of the home's breaker panel, however, some models made by Eaton (formerly Cutler-Hammer) and Siemens for panels manufactured by them install on the adjacent circuit breakers themselves and consist of a sliding arm for breakers ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
The flat parallel plug blades are polarized to prevent the hot and the neutral connections from being reversed. In addition, many versions have a molded obstruction bump on top of the adapter, to block the grounding prong and thus physically prevent forcible insertion of a 3-prong plug in the wrong orientation. [citation needed]
This mode is useful in a gym setting with multiple pieces of exercise equipment located far away from the controlling computer. All of the equipment could be connected to a single multiplexing box which in turn connects to the controlling computer over a long cable.
A male 4-pin "Kycon" power connector, which appears similar to a Mini-DIN connector Right-angle DC connector. Snap and lock DC power connectors look similar to Mini-DIN connectors but have either 3 or 4 thicker pins and a slightly larger mating shell. Because of this, they do not mate with any of the standardized Mini-DIN connectors.