Ads
related to: luer lock to connector adapter for generator to home gym system
Search results
Results From The WOW.Com Content Network
A syringe with a male luer lock fitting, and a needle with female luer lock fitting (purple) which screws into it. The Luer taper is a standardized system of small-scale fluid fittings used for making leak-free connections between a male-taper fitting and its mating female part on medical and laboratory instruments, including hypodermic syringe tips and needles or stopcocks and needles.
Early generator interlock kits consisted of two sliding steel or plastic (depending on the brand) plates held together by three bolts and installed on the front cover of the home's breaker panel, however, some models made by Eaton (formerly Cutler-Hammer) and Siemens for panels manufactured by them install on the adjacent circuit breakers themselves and consist of a sliding arm for breakers ...
This voltage source pin may also be used as an RS-232 DTR output signal to tell the Master or network adapter that the Slave unit is powered on and operational. This connector configuration differs slightly from the original CSAFE specification to allow backward compatibility with some existing RJ-11 based products.
"Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.
Genlock (generator locking) is a common technique where the video output of one source (or a specific reference signal from a signal generator) is used to synchronize other picture sources together. The aim in video applications is to ensure the coincidence of signals in time at a combining or switching point.
Locking connectors come in a variety of standardized configurations that follow the same general naming scheme except that the designations include an "L" for "locking". Locking connectors are designed so that different voltages and current ratings can not be accidentally intermated. [33] Many specific types exist; only a few are listed below.
A male 4-pin "Kycon" power connector, which appears similar to a Mini-DIN connector Right-angle DC connector. Snap and lock DC power connectors look similar to Mini-DIN connectors but have either 3 or 4 thicker pins and a slightly larger mating shell. Because of this, they do not mate with any of the standardized Mini-DIN connectors.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.