Ads
related to: 1 level slab home plans with pictures and dimensions full
Search results
Results From The WOW.Com Content Network
Split-level house. Split-level house is a design of house that was commonly built during the 1950s and 1960s. It has two nearly equal sections that are located on two different levels, with a short stairway in the corridor connecting them. Bi-level, split-entry, or raised ranch [17] Tri-level, quad-level, quintlevel etc. [17]
A splanch is not a ranch, and it is not a split level. Rather, it is a three-level house inside of a two-level skin. Typically, they are a center-hall type of home, built on a slab. On the ground level, there is a garage in front, loaded from either the side or the front of the house. Garages were one or two bays, depending on the size of the ...
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel-reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving (see below). [1] [2]
Elevation view of the Panthéon, Paris principal façade Floor plans of the Putnam House. A house plan [1] is a set of construction or working drawings (sometimes called blueprints) that define all the construction specifications of a residential house such as the dimensions, materials, layouts, installation methods and techniques.
A bi-level includes two short sets of stairs and two levels. [2] The entry is between floors. The front door opens to a landing. One short flight of stairs leads up to the top floor; another short flight of stairs leads down. The top floor tends to be full height ceilings with the living room, dining room, kitchen, bedrooms and bathrooms.
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...