Ads
related to: rs232 check tester led light bar
Search results
Results From The WOW.Com Content Network
In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data. It formally defines signals connecting between a DTE ( data terminal equipment ) such as a computer terminal or PC , and a DCE ( data circuit-terminating equipment or data communication ...
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Unlike GPIB, with the RS-232 interface, it is possible to connect and control only one device at a time. RS-232 is also a relatively slow interface with typical data rates of less than 20 KB/s. RS-232 is best suited for laboratory applications compatible with a slower, less rugged connection. It works on a ±24 volt supply.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
A voltage tester with three lamps to give an approximate indication of voltage magnitude. The test light is an electric lamp connected with one or two insulated wire leads. [1] Often, it takes the form of a screwdriver with the lamp connected between the tip of the screwdriver and a single lead that projects out the back of the screwdriver. By ...
While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer. [5] Commands are a series of one or more keywords, many of which take parameters.
This connector has been standardized for RS-232 as TIA-574. Some miniaturized electronics, particularly graphing calculators [ 5 ] and hand-held amateur and two-way radio equipment, [ 6 ] have serial ports using a phone connector , usually the smaller 2.5 or 3.5 mm connectors and the most basic 3-wire interface—transmit, receive and ground.
Digital Addressable Lighting Interface (DALI) is a trademark for network-based products that control lighting.The underlying technology was established by a consortium of lighting equipment manufacturers as a successor for 1-10 V/ 0–10 V lighting control systems, and as an open standard alternative to several proprietary protocols.