Ads
related to: rs232 check tester led light switch
Search results
Results From The WOW.Com Content Network
T1000-37 Tesuto Breakout box employing commonly used 37 position D-sub connectors that break out to banana jack test points. A four-port serial (RS-232) PCI Express ×1 expansion card with an octopus cable that breaks the card's DC-37 connector into four standard DE-9 connectors Example of a pocket-sized RS-232 breakout box that features switches to reconfigure or patch any or all the active ...
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Unlike GPIB, with the RS-232 interface, it is possible to connect and control only one device at a time. RS-232 is also a relatively slow interface with typical data rates of less than 20 KB/s. RS-232 is best suited for laboratory applications compatible with a slower, less rugged connection. It works on a ±24 volt supply.
Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and receivers must be able to withstand indefinite short circuits to the ground or to any voltage level up to ±25 volts. The slew rate, or how fast the signal changes between levels, is also controlled.
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
A voltage tester with three lamps to give an approximate indication of voltage magnitude. The test light is an electric lamp connected with one or two insulated wire leads. [1] Often, it takes the form of a screwdriver with the lamp connected between the tip of the screwdriver and a single lead that projects out the back of the screwdriver. By ...
While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer. [5] Commands are a series of one or more keywords, many of which take parameters.