Ad
related to: disable usb port sleep mode
Search results
Results From The WOW.Com Content Network
A yellow USB port denoting sleep-and-charge. Sleep-and-charge USB ports can be used to charge electronic devices even when the computer that hosts the ports is switched off. Normally, when a computer is powered off the USB ports are powered down.
DevSlp or DevSleep (sometimes referred to as device sleep or SATA DEVSLP) is a feature in some SATA devices which allows them to go into a low power "device sleep" mode when sent the appropriate signal, which uses one or two orders of magnitude less power than a traditional idle (about 5 mW, [1] but some drives can get as low as 2.5 mW [2]).
Drives listed with "Loaded: No" are defaulting to the older, slower Bulk Only Transport (BOT) mode. This may occur if the drive's USB controller, the Mac's USB port, or any attached USB hub doesn't support UASP mode. The Linux kernel has supported UAS since 8 June 2014 when the version 3.15 was released. [18]
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring. It was first released in ...
Standard USB hub ports can provide from the typical 500 mA/2.5 W of current, only 100 mA from non-hub ports. USB 3.0 and USB On-The-Go supply 1.8 A/9.0 W (for dedicated battery charging, 1.5 A/7.5 W full bandwidth or 900 mA/4.5 W high bandwidth), while FireWire can in theory supply up to 60 watts of power, although 10 to 20 watts is more typical.
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot .
Sleep mode and hibernation can be combined: the contents of RAM are copied to the non-volatile storage and the computer enters sleep mode. This approach combines the benefits of sleep mode and hibernation: The machine can resume instantaneously, and its state, including open and unsaved files, survives a power outage.
The All Programs mode has changed to an inline scrollable menu. As such, it is not possible to expand the All Programs menu in the Vista Start menu into flyout cascading menus. Subfolders inside the All Programs menu in the Vista Start menu cannot be opened in Windows Explorer by double clicking as was possible with the XP Start menu or Classic ...
Ad
related to: disable usb port sleep mode