Ads
related to: ham radio repeaters frequency
Search results
Results From The WOW.Com Content Network
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
Specific frequency allocations vary from country to country and between ITU regions as specified in the current ITU HF frequency allocations for amateur radio. [1] The list of frequency ranges is called a band allocation, which may be set by international agreements, and national regulations. The modes and types of allocations within each ...
The repeater receives on one radio frequency (the "input" frequency), demodulates the signal, and simultaneously re-transmits the information on its "output" frequency. All stations using the repeater transmit on the repeater's input frequency and receive on its output frequency. Since the repeater is usually located at an elevation higher than ...
The 2-meter amateur radio band is a portion of the VHF radio spectrum that comprises frequencies stretching from 144 MHz to 148 MHz [1] in International Telecommunication Union region (ITU) Regions 2 (North and South America plus Hawaii) and 3 (Asia and Oceania) [2] [3] and from 144 MHz to 146 MHz in ITU Region 1 (Europe, Africa, and Russia).
Common practice for 10-meter repeaters is to use a 100 kHz negative offset for repeater operation. Due to the very few available repeater channels, "odd-splits" (offsets differing from 100 kHz) and non-standard frequencies are rare and uncommon.
The 1.25-meter, 220 MHz or 222 MHz band is a portion of the VHF radio spectrum internationally allocated for amateur radio use on a primary basis in ITU Region 2, and it comprises frequencies from 220 MHz to 225 MHz. [1]