Ad
related to: home health quality assurance forms for checking welding of hydrocarbon piping repairs
Search results
Results From The WOW.Com Content Network
Engineering Critical Assessment (ECA) is a procedure by which the safety of a welded structure with defects or flaws can be determined. ECAs utilize the material properties and expected stress history to determine a flaw acceptance criteria which will ensure that welds will not fail during the construction or service life of the welded structure. [1]
Inline coherent imaging (ICI) is a recently developed interferometric technique based on optical coherence tomography [8] that is used for quality assurance of keyhole laser beam welding, a welding method that is gaining popularity in a variety of industries. ICI aims a low-powered broadband light source through the same optical path as the ...
During laser welding, air bubbles can form and cause a degradation in the mechanical properties of the joint. Current inspection techniques are limited to finding air bubbles on the surface of the weld (optical and scanning electron microscopy). Destructive testing is usually required to find volumetric flaws.
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...
In addition to welders and welding machine operators, there are also schemes to independently certify welding inspectors and related specialities. The duties of the welding inspector are described in ISO 14731; [12] however the requirement for inspector certification are not standardized, so there are differences in requirement between the various schemes.
Dye penetrant inspection (DP), also called liquid penetrate inspection (LPI) or penetrant testing (PT), is a widely applied and low-cost inspection method used to check surface-breaking defects in all non-porous materials (metals, plastics, or ceramics).
Europe and the rest of the world has an equivalent system of codes. Pressure piping is generally pipe that must carry pressures greater than 10 to 25 atmospheres, although definitions vary. To ensure safe operation of the system, the manufacture, storage, welding, testing, etc. of pressure piping must meet stringent quality standards.
All four of these factors are considered during the initial design of a system using hydrogen, and is typically accomplished by limiting the contact between susceptible metals and hydrogen, either by spacing, electroplating, surface cleaning, material choice, and quality assurance during manufacturing, welding, and installation.