Search results
Results From The WOW.Com Content Network
The equation is only valid for creeping flow, i.e. in the slowest limit of laminar flow. The equation was derived by Kozeny (1927) [ 1 ] and Carman (1937, 1956) [ 2 ] [ 3 ] [ 4 ] from a starting point of (a) modelling fluid flow in a packed bed as laminar fluid flow in a collection of curving passages/tubes crossing the packed bed and (b ...
In civil engineering, clearance refers to the difference between the loading gauge and the structure gauge in the case of railroad cars or trams, or the difference between the size of any vehicle and the width/height of doors, the width/height of an overpass or the diameter of a tunnel as well as the air draft under a bridge, the width of a lock or diameter of a tunnel in the case of watercraft.
Refrigerator van for the transportation of bananas. ... [2] Use In long-distance ... Door height 1.90 m Door width 2,70 m 1) Refrigerated and insulated vans ...
The limit of this formula, as α goes to 90°, gives the maximum weight of a pendant drop for a liquid with a given surface tension, . m g = π d γ {\displaystyle \,mg=\pi d\gamma } This relationship is the basis of a convenient method of measuring surface tension, commonly used in the petroleum industry.
A road car usually has a ride height around 16–17 cm (6.3–6.7 in), while an SUV usually lies around 19–22 cm (7.5–8.7 in). Two well-known extremes are the Ferrari F40 with a 12.5 cm (4.9 in) ride height [1] and the Hummer H1 with a 40.64 cm (16.0 in) ride height.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The heat pump itself can be improved by increasing the size of the internal heat exchangers, which in turn increases the efficiency (and the cost) relative to the power of the compressor, and also by reducing the system's internal temperature gap over the compressor. Obviously, this latter measure makes some heat pumps unsuitable to produce ...
The signal from the photodiodes is used to back-calculate a drop size distribution. A number of lenses allow measurements from 1.2 to 1800 μm. The optical imaging method uses a pulsed light, laser or strobe, to generate the shadow graphic image used to determine the size of the drop in the measurement volume.