Search results
Results From The WOW.Com Content Network
The latter is the case when the sample times are equally spaced and sinusoids chosen as sines and cosines equally spaced in pairs on the frequency interval 0 to a half cycle per sample (spaced by 1/N cycles per sample, omitting the sine phases at 0 and maximum frequency where they are identically zero).
The image sampling frequency is the repetition rate of the sensor integration period. Since the integration period may be significantly shorter than the time between repetitions, the sampling frequency can be different from the inverse of the sample time: 50 Hz – PAL video; 60 / 1.001 Hz ~= 59.94 Hz – NTSC video
The Nyquist–Shannon sampling theorem is an essential principle for digital signal processing linking the frequency range of a signal and the sample rate required to avoid a type of distortion called aliasing. The theorem states that the sample rate must be at least twice the bandwidth of the signal to avoid aliasing.
The samples (sometimes called frequency bins) are numbered consecutively, corresponding to a frequency normalization by . [2]: p.56 eq.(16) [3] The normalized Nyquist frequency is with the unit 1 / N th cycle/sample. Angular frequency, denoted by and with the unit radians per second, can be similarly normalized.
The residual phase term adds only minor perturbations to this characteristic within the frequency range /. At frequencies outside this range, Φ 2(ω) deviates rapidly from π /4, and so the total phase will deviate seriously from a square law there. Fortunately, the energy content of the chirp spectrum is very small at these frequencies (as is ...
The selection of the sample rate was based primarily on the need to reproduce the audible frequency range of 20–20,000 Hz (20 kHz). The Nyquist–Shannon sampling theorem states that a sampling rate of more than twice the maximum frequency of the signal to be recorded is needed, resulting in a required rate of greater than 40 kHz.
The frequency halfway between the stop and start frequencies on a spectrum analyzer display is known as the center frequency. This is the frequency that is in the middle of the display's frequency axis. Span specifies the range between the start and stop frequencies. These two parameters allow for adjustment of the display within the frequency ...
The sampling theorem states that sampling frequency would have to be greater than 200 Hz. Sampling at four times that rate requires a sampling frequency of 800 Hz. This gives the anti-aliasing filter a transition band of 300 Hz ((f s /2) − B = (800 Hz/2) − 100 Hz = 300 Hz) instead of 0 Hz if the sampling frequency was 200 Hz. Achieving an ...