Search results
Results From The WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
A back countersink, also known as an inserted countersink, is a two piece countersink used on tough to reach areas. One component is a rod that is inserted into the existing hole in the workpieces; the other component is the cutter, which is attached to the rod, or extends out of it, after it is in position. [ 3 ]
It relates to spindle speed via variables such as cutter diameter (for rotating cutters) or workpiece diameter (for lathe work). SFM is a combination of diameter and the velocity ( RPM ) of the material measured in feet-per-minute as the spindle of a milling machine or lathe . 1 SFM equals 0.00508 surface meter per second (meter per second, or ...
It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall. If the value is larger than 1 it is called a trumpet. Depending on the material being cut, feed rate and other factors, a cutting tool with the optimum K factor should be used.
The speeds and feeds used are varied to suit a combination of variables. The speed at which the piece advances through the cutter is called feed rate , or just feed ; it is most often measured as distance per time (inches per minute [in/min or ipm] or millimeters per minute [mm/min]), although distance per revolution or per cutter tooth are ...
Form tools can be made of cobalt steel, carbide, or high-speed steel. Carbide requires additional care because it is very brittle and will chip if chatter occurs. A drawback when using form tools is that the feed into the work is usually slow, 0.0005" to 0.0012" per revolution depending on the width of the tool.
Whereas a counterbore is a flat-bottomed enlargement of a smaller coaxial hole, a countersink is a conical enlargement of such. A spotface often takes the form of a very shallow counterbore. As mentioned above, the cutters that produce counterbores are often also called counterbores; sometimes, to avoid ambiguity, the term counterbore cutter is ...
Carbide tools can withstand higher temperatures at the cutter-workpiece interface than standard high-speed steel tools (which is a principal reason enabling the faster machining). Carbide is usually superior for the cutting of tough materials such as carbon steel or stainless steel , as well as in situations where other cutting tools would wear ...