Search results
Results From The WOW.Com Content Network
If the spandrel is solid, usually the case in a masonry or stone arch bridge, the bridge is called a closed-spandrel deck arch bridge. If the deck is supported by a number of vertical columns rising from the arch, the bridge is known as an open-spandrel deck arch bridge. The Alexander Hamilton Bridge is an example of an open-spandrel arch ...
The single arch of the bridge has a span of 31.4 meters and a rise of 11.42 meters, which was unusually flat for the time. The structure features two different masonry techniques: the lower part is made of gneiss blocks, dry-laid, while the upper part is a superposition of layers made of gneiss flakes and lime, interspersed with bands of stone. [9]
The deck is connected to the arch by 12 pairs of vertical hangers at the arches and the deck intersection point, 60 m from the centre of the bridge, rigidly joined by a cross brace. Each arch is embedded at the ends in a reinforced concrete block (the smallest being 6 m long, 7 m high and 5 m wide) connected by means of a joint of 28 steel bars ...
An unreinforced concrete arch is technically a masonry arch that use only very small stones, that is the aggregate of the concrete, sand and gravel. Such an arch would not stand without mortar. Some modern bridges are built masonry style with precast concrete blocks, like Gladesville Bridge that has a span of 305 metres (1000 ft). These types ...
The through arch bridge usually consists of two ribs, [5] although there are examples like the Hulme Arch Bridge of through arches with a single rib. When the two arches are built in parallel planes, the structure is a parallel rib arch bridge. When the two arch ribs lean together and shorten the distance between the arches near the top, the ...
Because both the arch and the tie are mainly subject to axial forces, their cross sections can be very small. Usually, transverse bending in the deck is bigger than bending in longitudinal direction. Therefore, a concrete deck that spans between the arches is a good solution for bridges with arch distances that are not too large.
In this case, the height of the structure, measured between the top of the deck and the ground, is between the values a/3 and a/2, where a denotes the span of the arch, which is generally a semicircular or elliptical arch. [7] The thickness e of the pier depends solely on the span of the arches: a/10 < e < a/8.
This diagram was created with Inkscape. This SVG diagram shows a very simple image. Drawing uncomplicated graphics with a text editor seems more adequate than using a vector graphics program, and will often result in a dramatic reduction of file size.