Search results
Results From The WOW.Com Content Network
A rudder alone will turn a conventional fixed-wing aircraft, but much more slowly than if ailerons are also used in conjunction. Sometimes pilots may intentionally operate the rudder and ailerons in opposite directions in a maneuver called a slip or sideslip. This may be done to overcome crosswinds and keep the fuselage in line with the runway ...
The rudder may also be called upon to counter-act the adverse yaw produced by the roll-control surfaces. If rudder is continuously applied in level flight the aircraft will yaw initially in the direction of the applied rudder – the primary effect of rudder. After a few seconds the aircraft will tend to bank in the direction of yaw.
The design of the rudder travel limiter on the Airbus A300-600 was cited as a contributing factor to the crash of American Airlines Flight 587. In addition to a low rudder pedal sensitivity compared to other aircraft, the A300-600 had a variable stop design, contrary to earlier iterations of the A300, which used a variable ratio design. [4]
A balanced rudder is a rudder in which the axis of rotation of the rudder is behind its front edge. This means that when the rudder is turned, the pressure of water caused by the ship's movement through the water acts upon the forward part to exert a force which increases the angle of deflection, so counteracting the pressure acting on the after part, which acts to reduce the angle of deflection.
A rudder pedal is a foot-operated aircraft flight control interface for controlling the rudder of an aircraft. [1] [2] The usual set-up in modern aircraft is that each pilot has a pedal set consisting of a pair of pedals, with one pedal for each foot. Each right and left pedal works together so that one pedal pops out when the other is ...
The deceleron is an aileron that functions normally in flight but can split in half such that the top half goes up as the bottom half goes down to brake. This technique was first used on the F-89 Scorpion and has since been used by Northrop on several aircraft, including the B-2 Spirit. The Space Shuttle used a similar system. The vertically ...
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
From his perch in Primary Flight Control (PriFly, or the "tower"), he, along with his assistant, maintains visual control of all aircraft operating in the carrier control zone (surface to and including 2,500 feet (760 m), within a circular limit defined by 5 nautical miles (9.3 km; 5.8 mi) horizontal radius from the carrier), and aircraft ...