Search results
Results From The WOW.Com Content Network
Figure 2: A negative-feedback amplifier. The circuit can be explained by viewing the transistor as being under the control of negative feedback.From this viewpoint, a common-collector stage (Fig. 1) is an amplifier with full series negative feedback.
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE.The following table is split into two groups based on whether it has a graphical visual interface or not.
Figure 2: Adding an emitter resistor decreases gain, but increases linearity and stability. Common-emitter amplifiers give the amplifier an inverted output and can have a very high gain that may vary widely from one transistor to the next. The gain is a strong function of both temperature and bias current, and so the actual gain is somewhat ...
The result is that the BJT makes a good switch that is controlled by its base input. The BJT also makes a good amplifier, since it can multiply a weak input signal to about 100 times its original strength. Networks of BJTs are used to make powerful amplifiers with many different applications. In the discussion below, focus is on the NPN BJT.
Full hybrid-pi model. The full model introduces the virtual terminal, B′, so that the base spreading resistance, r bb, (the bulk resistance between the base contact and the active region of the base under the emitter) and r b′e (representing the base current required to make up for recombination of minority carriers in the base region) can be represented separately.
The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier. (See classification of amplifiers). As a transconductance amplifier, the input voltage is seen as modulating the current going to the load.
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.
Darlington Transistor (NPN-type) In electronics, a Darlington configuration (commonly called as a Darlington pair) is a circuit consisting of two bipolar transistors with the emitter of one transistor connected to the base of the other, such that the current amplified by the first transistor is amplified further by the second one. [1]