Search results
Results From The WOW.Com Content Network
The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If there are multiple outlets, an RF splitter is used to divide the signal among them; outlets on the splitter are connected to television outlets at each location (living room, rec room, bedrooms, den, for example).
Other ceramic pieces would typically be used as a junction point between the wiring system proper, and the more flexible cloth-clad wiring found in light fixtures or other permanent, hard-wired devices. When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic ...
Electrical wiring is an electrical installation of cabling and associated devices such as switches, distribution boards, sockets, and light fittings in a structure. Wiring is subject to safety standards for design and installation.
The installation of a conventional wired telephone set has four connection points, each of which may be hardwired, but more often use a plug and socket: telephone line to phone cord: The wall jack. This connection is the most standardized, and often regulated as the boundary between an individual's telephone and the telephone network.
Chassis or panel connectors permanently attached to a piece of equipment so users can connect a cable to a stationary device; PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors)
Some types of conduit are approved for direct encasement in concrete. This is commonly used in commercial buildings to allow electrical and communication outlets to be installed in the middle of large open areas. For example, retail display cases and open-office areas use floor-mounted conduit boxes to connect power and communications cables.
A centrifugal fan is a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid. Centrifugal fans often contain a ducted housing to direct outgoing air in a specific direction or across a heat sink; such a fan is also called a blower, blower fan, or squirrel-cage fan (because it looks like a hamster wheel).
Extension of the analogy results in the verb to mate being used to describe the process of connecting two corresponding parts together. In some cases (notably electrical power connectors), the gender of connectors is selected according to rigid rules which enforce a sense of one-way directionality (e.g. a flow of power from one device to another).