Search results
Results From The WOW.Com Content Network
A quick release skewer is a mechanism for attaching a wheel to a bicycle. It consists of a rod threaded on one end and with a lever operated cam assembly on the other. The rod is inserted into the hollow axle of the wheel, a special nut is threaded on, and the lever is closed to tighten the cam and secure the wheel to the fork.
Squeezing the brake lever tightens the cable against the channel to produce braking friction. [49] A return spring slackens the cable when the brake lever is released, no adjustment is required, and the brake becomes more forceful when wet. Husted said his inspiration was the band brake used on industrial machinery. [50]
Shimano STI Dual Control shifter and brake lever: 1. Main lever 2. Release lever A. Pulling the main lever towards the rider applies the brake B. Pushing the main lever towards the center of the bike downshifts one, two or three gears depending on how far the lever is pushed (right hand shifter) or changes from a small chainring to a larger chainring (left hand shifter)
The cable was particularly intended for use in conjunction with bicycle brakes. The Bowden Brake was launched amidst a flurry of enthusiasm in the cycle press in 1896. It consisted of a stirrup, pulled up by the cable from a handlebar mounted lever, with rubber pads acting against the rear wheel rim.
An early design for a leg mechanism called the Plantigrade Machine by Pafnuty Chebyshev was shown at the Exposition Universelle (1878). The original engravings for this leg mechanism are available. [2] The design of the leg mechanism for the Ohio State Adaptive Suspension Vehicle (ASV) is presented in the 1988 book Machines that Walk. [3]
An overrun brake (called a surge brake when invented) is a brake system commonly used on small trailers, where the motion of the trailer with respect to the towing vehicle is used to actuate the brake. The early systems were fitted with a spring system which was not very effective.
Work Completed: Replaced brake servo and master cylinder, track-rod ends (and did wheel alignment and tracking), re-cored radiator, electrics professionally checked, replaced the hazard warning light switch, resoldered the scotch locks in the wiring loom, fitted a new metal plate at the bottom of the aerial, lubricated left-side power window ...
A basic Highfield lever. A Highfield lever is a lever device which allows tension to be rapidly set up in a wire and equally rapidly released to the required extent. It is frequently used in sailing boats where tension in some part of the rigging needs to be adjusted to a pre-set amount as the wind impinges on one side of the sails or the other.