Ads
related to: 34 pin floppy disk connector
Search results
Results From The WOW.Com Content Network
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7] A separate connector is provided for DC power. [1]
A 34-pin control cable and a 20-pin data cable for an ST-412 drive connected to a controller card. A 4-pin Molex connector supplying power to the drive can not be seen in this image. In the ST-506 interface, the drive connects to a controller card with two ribbon cables carrying signals, while a third cable provides power.
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
Some operating systems required code changes to support floppy disks with capacities far larger than any standard floppy disk drive. Also, standard-floppy disk drive emulation proved to be unsuitable for certain high-capacity floppy disk drives such as Iomega Zip drives. Later the ARMD-HDD, ARMD-"Hard disk device", variant was developed to ...
Enhanced Small Disk Interface (ESDI) is a hard disk drive interface designed by Maxtor Corporation in 1983 to be a follow-on to the ST-412/506 interface. [1] ESDI improved on ST-506 by moving certain parts that were traditionally kept on the controller (such as the data separator) into the drives themselves, and also generalizing the control bus such that more kinds of devices (such as ...
Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...