Ads
related to: which best saucepan set with handle goes bad on back of hand meaning in tamil
Search results
Results From The WOW.Com Content Network
Frying pan – a flat-bottomed pan used for frying, searing, and browning foods; Tava – a large flat, concave or convex disc-shaped frying pan (dripping pan) made from metal, usually sheet iron, cast iron, sheet steel or aluminium. It is used in South, Central, and West Asia, as well as in Caucasus, for cooking a variety of flatbreads and as ...
Tin linings sufficiently robust for cooking are wiped onto copper by hand, producing a .35–45-mm-thick lining. [16] Decorative copper cookware, i.e., a pot or pan less than 1 mm thick and therefore unsuited to cooking, will often be electroplate lined with tin. Should a wiped tin lining be damaged or wear out the cookware can be re-tinned ...
Copper saucepan without lid Saucepan with a lid. A saucepan is one of the basic forms of cookware, in the form of a round cooking vessel, typically 3.5 to 4 inches (90 to 100 mm) deep, and wide enough to hold at least 1 US quart (33 imp fl oz; 950 ml) of water, with sizes typically ranging up to 4 US quarts (130 imp fl oz; 3.8 L), [1] and having a long handle protruding from the vessel.
Typically sold in a set that measures dry or wet ingredients in amounts from 1/4 teaspoon (1.25 ml) up to 1 tablespoon (15 ml). [9] Meat grinder: Mincer: Operated with a hand-crank, this presses meat through a chopping or pureeing attachment. Meat tenderiser: Used to tenderize meats in preparation for cooking. Usually shaped like a mallet. Meat ...
A stainless steel frying pan. A frying pan, frypan, or skillet is a flat-bottomed pan used for frying, searing, and browning foods. It is typically 20 to 30 cm (8 to 12 in) in diameter with relatively low sides that flare outwards, a long handle, and no lid. Larger pans may have a small grab handle opposite the main handle.
The earliest style of bakelite handles feature two screws, just a little more than an inch apart, near the pan side of the handle. Later, a screw was located at either end of the handle. By 1968, in a cost-cutting measure, the bakelite was made from one piece and pressed onto the attached metal handle.